7/21/2023 0 Comments Rockshaft draft control![]() The process of adjusting the side link float is on page 132 of the manual for your tractor, available for free in PDF form if you don't want to retrieve it from the little pocket behind the seat to read the paper version. The best way to keep your implement from raising off the ground is to give the 3pt lots of float, or lower the position past the point that you want the. Draft control changes the position of the implement to reduce the draft on the tractor, or the amount of 'pull'. Many bush hogs have a pivoting hitch mast that will let the rear of the cutter move up and down relative to the front, allowing it to follow the contours front-and-back somewhat. Draft control is used to do what it says, control the draft of the tractor. Now the draft links can wiggle up and down a little with regard to the side links and thus each other to allow the cutter to followed angled ground a little better. When there is nothing attached to the 3 point, remove the linch pin from the end of these rectangular pins and rotate the pins so that each one fits between the tabs in the side link, then reinstall the linch pins. To activate Draft Control mode, first adjust the slope depth setting to somewhere between 1 and 5 the help page in the Operations Center will provide suggestions for different types of implements. ![]() ![]() There is a rectangular-headed pin where the side link attaches to the draft link on each side. What you want to do is allow float in the 3 point side links. Draft control will not change how the bush hog follows ground contour, leave it set to "off."
0 Comments
Leave a Reply. |